The selected parameter will flash ( “OP” on-time, “CL” off-time, “LOP” cycle times ( “-” represents infinite cycles)), then you can adjust the values by “UP”, “DOWN” button to adjust the parameter value, support long press (rapid increase or decrease) and short press (increase or decrease one unit). P3.2), short press the “SET” button to select the parameter to be set. In the main interface, long press “SET” button for 2 seconds then release to enter mode selection interface, short press “UP” or “DOWN” button to select the mode (P1.1 ~ P-4) you need. The current operating mode (P1.1 mode in default) will flash when the module is powered up. Determine the operating mode of the relay. After setting the mode, short press “SET” button can check all the set parameters of the mode at present in the main interface, easy and convenient!.There are “OP”, “CL”, “LOP” in some modes (such as the mode P3.1, P3.2), short press “SET” button will display “OP” and the corresponding time, “CL” and the corresponding time, “LOP” and the corresponding number of times.If there is only “OP” time in some modes (such as the mode P1.1, P1.2, P1.3), short press the “SET” button to display the “OP” and the corresponding time only.In the main interface (display 000), short press “SET” button, it will display “OP” ( “CL”, “LOP”) and the corresponding time XXX.If you switch to P1.2 mode, the “OP” time of P1.2 mode will be 5 seconds too. For example, in P1.1 mode, the on-time “OP” is set 5 seconds. These parameters are independent, but are shared by each mode.“LOP” – The number of cycles (1-999 times, “-” represents infinite cycles). ![]()
0 Comments
Leave a Reply. |